Fibroblast Skin Tightening

It is a Revolutionary treatment. Fibroblast-Skin tightening treatment is NON-invasive, NON-surgical procedure where no scalpels or any surgical instruments are used. Fibroblast is basically an electrical arc that is transmitted through a small probe. This innovative technique cannot cause the so-called “over lifting”, as it only affects excess/loose skin which returns to its “original state”.

HOW FIBROBLAST-SKIN TIGHTENING WORKS

BENEFITS

Frequently Asked Questions

Fibroblast Skin-Tightening treatment uses small electric arch which is transmitted through a small probe. The probe itself doesn’t go in to the skin or even touch the skin.
Tissues treated “coagulate” & “sublimate” and we avoid spreading unwanted heat to the surrounding areas. The principle is to ionize gases in the air to create a small electrical arch, similar to a tiny lightning bolt, with which epidermal areas, which are affected by aesthetic problems, may be treated without spreading unwanted heat to the surrounding areas.

The arc causes superficial damage to the upper dermal layer of skin and transmits heat to the lower levels of skin. This causes the new skin to generate collagen and elastin fibres that can fade as we age.

There is no special pre-treatment needed. 

Fibroblast-Skin Tightening is a NON-invasive procedure with minimal level of pain. It is virtually painless, as the treated area is numbed before the treatment. After the treatment, the treated area might be slightly reddish and some patients may experience some swelling (only for areas around the eyes). At the site of each spot a small crust will form. They should not be touched and you should wait for 4–5 days for them to fall off naturally. 

With the help of Fibroblast-Skin Tightening it is possible to treat various skin problems (acne), achieve the “lifting effect” of the loose skin or correct or remove scars.

Upper eyelids

Lower eyelids

Neck tightening

Mid-face lifting

Wrinkles

Worry lines

Crow’s feet

Smile lines

Labial lines

Do not pick carbon crust; it will fall off in a few days

  • After the treatment continue applying the aftercare cream on the treated area as long as it is sensitive or when you are exposed to sun, as it contains SPF and protects the treated area.
  • Avoid sauna, pools, solariums or any kind of exposure to activities which present risk for infection of the treated area.
  • Make sure to protect the treated area from direct sun until the skin is completely regenerated (2–3 weeks).
  • Do not apply products containing alcohol or other scents.
  • Do not cover with plasters or covers.

Do not use makeup after the treatment, as it generally is not sterile. First 5–6 days after the treatment, until the crusts fall off, use the antiseptic product and the aftercare cream, applying it softly to the treated area. When the crusts fall off, you may apply some makeup if necessary, as the cream the therapist gives you contains skin powder which covers the crusts and the blush.

The results are visible immediately, but the end results follow after 3–4 weeks after the treatment.

Usually Fibroblast is 1 sessions treatment. It depends on the state of the patients’ skin and the desired degree of correction. The procedure may be repeated after the skin is fully regenerated. 

The results of the Fibroblast-Skin Tightening treatment are permanent and may be visible for years. But we should acknowledge that the aging process is continuous and thus the skin ages every day after the procedure and this cannot be stopped. The results of this method are permanent. Average results last from 2-4 years